Home Theater Forum and Systems banner

volt

  1. IR 12 volt trigger

    Remotes | Cables | Accessories | Tweaks
    Hi guys, new to the forum. I just recently purchased a Panamax M5300 power conditioner with always on and switched outlets. I would like to take advantage of the switched outlets. There is one bank (switched outlets) dedicated to high current devices (receiver and subwoofer). I want to put...
  2. Receiver 12 volt trigger

    Home Theater Receivers | Processors | Amps
    On the back of receivers there is a 12volt trigger jack . I would like for someone to please help me . I have not seen what the plug looks like to buy one. I do not want to try the wrong one and burn my stuff up- especially when I just bought a new receiver. I saw at RadioShack, they had a six...
  3. can a 12 volt trigger work with sony s-link?

    Home Theater Receivers | Processors | Amps
    Is there a way to operate a sony s-link device with a 12 volt trigger? Basically I'm looking to have an Emotiva UMC-1 trigger a sony ta-n9000es amp on/off. But the sony only has an "s-link ctrl A1" jack and not a 12 volt trigger control. Here is a description of the s-link protocol...
  4. 12 Volt Trigger Advice

    Home Theater Receivers | Processors | Amps
    Hi, I was considering a new Onkyo 808 or 1008 receiver. Just wondering how you can 12v trigger an external amp with this receiver in Zone 1. It has a 12v trigger for zone 2 and 3 but not zone 1. Any advice would be appreciated. Mark
  5. 12 Volt Trigger Advice

    Home Theater Receivers | Processors | Amps
    Hi, I just bought an Emotiva XPA-5 and intended to use my Harmony remote to turn it on and off. However, I have now learnt that you need a 12v trigger to do this. Unfortunately my Yamaha RX-V1000 receiver does not have one. Are there after market solutions, ie can I buy an independent 12v...
  6. Is 1 volt too low to feed a pro amp?

    Home Theater Receivers | Processors | Amps
    How much signal is my Pro amp missing out on if my receiver Pre out is only sending out a 1v unbalanced signal. Is 1 volt low enuff to justify the purchase of an art cleanbox? I am using an Onkyo receiver (TX-SR600) and an ep1500 pro amp. I just think the amp is not getting all the signal it...
Top