Home Theater Forum and Systems banner

volume

  1. Sound bar volume dropped off? new modem/router?

    AV Home Theater
    I have a 43" Sharp tv LC-43LB601U and Samsung sound bar HW-N450/ZA out in my work shop. The only media that i use this for is all wifi type apps, pandora, netflix, youtube etc. Recently the sound bar volume while using the apps has dropped on significantly. Just to use numbers, where 45 was...
  2. I connected Sony SS TSF500 (3Ohm) speaker and Onkyo TX-SR444 and now facing low volume

    System Setup and Connection
    I have Sony SS TSF500 (3 ohm) speaker and Onkyo TX-SR444 connected, the problem is there is not much audio volume coming from the speaker. To check if it was speaker issue, I replaced it with another 3 ohm speaker but the result the same. Also I reset the Onkyo AV incase there was some setting...
  3. Driver displacement volume

    DIY Subwoofers - General Discussion
    DOES ANYONE KNOW THE Audiopipe TS-AR 15 15" Single 4 ohm EXT Woofer Displacement VOLUME IN CUBIC INCHS HOW MUCH SPACE DOES THE DRIVER TAKES UP SOME SUBS LIST THE SPECS LIKE Rockford Fosgate AN SUNDOWN AUDIO I NEED TO KNOW THE SPEC FOR Audiopipe TS-AR 15 15" Single 4 ohm MY FOR BOX DESIGN SPECS
  4. In need of a Pre-Amp and a room correcting DSP

    Audio Processing
    Hello Everyone, Currently I am running a set of powered monitors along side a pair of powered subwoofers in my living room. I am currently lending my Emotiva Stealth DC-1 to take care of pre-amp duties, but I would like to have it back at my desktop. Having measured the setup, the bass needs a...
  5. Volume Controls are controlling balance

    System Setup and Connection
    Hi and Merry Christmas, I'm helping a friend set up his whole house speaker system. He just purchased the house and it had approx. 10 pairs of in ceiling speakers throughout the house with a pair in most every room. There are in-wall in room volume controls for each of the speaker pairs. The...
  6. Volume enclosure calculator-anyone else having a problem?

    DIY Subwoofers - General Discussion
    This page doesnt work for me anymore. I get a page with some links on the left. http://www.hometheatershack.com/forums/enclosure-volume-calculator/
  7. Audyssey dynamic volume or Yamaha DSP?

    Home Theater System Recommendations
    So I'm ready to buy a new AVR but the only feature that matters most to me right now is some form of dynamic volume control. I'm pretty tired of having to turn the volume up and down while watching a movie. So I see Audyssey Dynamic volume looks to do what I want. Can anyone shed light on if it...
  8. how to balance Sub volume with speakers?

    REW Forum
    I have two different branded subwoofers, one from REL and other from PSB. My front speakers are B&W 802D's. I am trying to balance the volume of Sub's with speakers using REW SPL Meter with REW's signal generator using sign wave. Keeping the volume constant on AVP, I balanced my sub and...
  9. Hammer Horror Collection: Volume 1 - Blu-ray Review

    Official DVD and Blu-ray Reviews
    http://www.hometheatershack.com/gallery/file.php?n=55170 Title: Hammer Horror Classic Collection: Volume 1 Movie: :3.5stars: Video: :4stars: Audio: :3stars: Extras: :halfstar: HTS Overall Score:64 WARNING: THE SCORES ABOVE ARE A COMBINED SCORE FROM ALL 5 FILMS, THE...
  10. What should be my volume level on my processor?

    REW Forum
    This is the first time I will be using REW, I have M-Audio Avid MobilePre MkII connected to McIntosh MX 121 processor. There is a volume on M-Audio Avid MobilePre MkII and on MX 121. Questions which volume should set to what?
  11. Mitsubishi wd 52627 Low volume

    General Service and Technical Information
    The volume is so low that you can barely hear it. The volume is all the way up. Is there something in the set up I am not getting?
  12. Manual SUB EQ and Dolby volume

    Audio Processing
    Hello again HTS.. If you've read my previous posts about audyssey problems and harsh sound from speakers, I've made quite a progression.. Previous post (if interrested): http://www.hometheatershack.com/forums/diy-speakers/119570-harsh-piercing-sound.html...
  13. Volume knob restarting br disc

    System Setup and Connection
    I have a Sony dh740 av receiver and a lg blue ray player (not sure of the model) when ever I adjust the volume on the receiver while I'm watching a blue ray disc it will restart the movie, it does it if I adjust the volume by remote control or the knob on the receiver. Hdmi runs from the br...
  14. Different sweep volume levels result in different responses

    REW Forum
    I took 3 sweeps at different volume levels (I calibrated each using SPL meter), no other changes. purple = 85dB green = 75dB red = 65dB The 200hz and up region is what I was expecting to see across the entire frequency spectrum. Look at how bloated the bass gets on the quieter sweeps. The 65dB...
  15. Sony STR-DN850 and raw volume

    System Setup and Connection
    I have most of my 7.1(2?) HT set up and operational. It seems to me to be quiet. I am not expecting a theatre style PA, but I thought I would be able to crank up a DVD (when the wife and kids are out). I can turn this thing up to 'MAX' (70) and talk to someone just raising my voice a little...
  16. Low volume from receiver (Yamaha RX-A2030)

    Home Theater Receivers | Processors | Amps
    Hi guys, I'm having a problem with my brand new RX-A2030 and wonder if someone here can help me before I contact Yamaha technical service. The RX-A2030 is replacing a >10 year-old receiver that was working fine (B&K components). I have a "whole house" sound set up with individual volume knobs...
  17. Understanding maximum volume (0db), with Audyssey

    Audio Processing
    Hello HTS! It's been a while, since i posted a thread on these forums, feel free to move it, if i got the place wrong. I recently upgraded my system with a used Denon 4311 - to get MultiXT32. I absolutely love it - everything sounds like heaven, and the 140w pr. ch (170w in 2ch) does a good...
  18. REW with USB mic - which input volume?

    REW Forum
    Hi all I use REW with a XTZ microphone pro (USB). I've problems finding the optimal input volume: When I use "check levels", the help-file says: "if you are using a USB microphone, leave the volume control at the unity gain (in my case: 0.631). But the problem is, that after setting the output...
  19. Dayton um 18-22 box volume

    DIY Subwoofers - General Discussion
    Hi Im having issues with WinISD, It wont accept the parameters or wdr file. Could someone please calculate the volume and port size on a (Dayton um 18-22 18" Ultimax DVC) with one port at about 19hz for me please. Powered by a Dayton sa1000. Thanks
  20. How do I calculate the brace volume?

    DIY Subwoofers - General Discussion
    If I have a 6ft^3 enclosure, how do I calculate the brace volume? I don't know what to put into the calculator.
Top