Search Results for ‘work?’

Currently, my receiver does BM/TA on the MCH analogue inputs (via an A/D/A that I have found satisfactorily transparent, even with SACD and DVD-A, for a number of years). I am pretty sure that if I add a BFD or an Antimode 8033 to my current gear, either one will EQ my sub output from my...

I currently have a eD a7s-650 (dual 13" sealed) and want something with a bit more output. I love the idea of a stealth installation like IB and think I want to go this route as long as the SPL would avg roughly 123db+. My room is 3700+/- cu ft so I'm thinking one manifold with 4 18" Fi (soon to...

Hey all, I am very new to IB. I currently have 2 Tuba THT horns that I built and they have been awesome in terms of output 20hz and up .I have been looking into building something new due to the fact these horns have no output below 20hz. I have gone from multiple sealed boxes, to a couple...

What is the advantage to Passive Radiators? I see them on smaller subs more than larger subs. What is there job exactly and how do they work? Some subs that use passive radiators: http://www.salksound.com/SongSub.shtml http://www.definitivetech.com/Products/Series/SuperCubeSeries.aspx

I was thinking about this at work yesterday. Is it so that as long as you know the parameters of the driver, you can always make a respectable sub-woofer?? It might need an enclosure the size of a house, but it would sound okay right?? Is it the quest for "usable" sized enclosures that make...

ok,,,so i am new to the diy seen,,started off needing to build a center channel to fit a media cabinet i had,, I was blown away by the sound quality> I thought i always had good speakers that were mid to high grade,turns out there all ... its amazing what you can do for 300.00 bucks. So now i...

I'm just getting REW setup and working. I've got a Dell D410 I've sourced exclusively for REW work. I picked up an external sound blaster to get the appropriate input. I'm using a RS 2050 meter with the HTS provided calibration file. I calibrated the sound card and created a .cal file which...

I want to build a small sub with the 8" speaker with following parameters: Specifications: •Power capacity: 120W/240W RMS/peak •Frequency response: 25Hz ~ 1KHz •Nominal impedance: 4Ω •Voice coil diameter: 2" •Magnet weight: 47oz. •Sensitivity: 87dB W/M •Fs: 25.7Hz •Re: 3.4Ω •Le: 2.47mH •Qms...