Home Theater Forum and Systems banner

xls10

  1. Multiple XLS10 sealed subs combined with 2 'ULF' subs

    DIY Subwoofers - General Discussion
    I'm planning a room change and it seems that multiple smaller subs might help to supplement an existing pair of sealed 15" subs I have already built in particular to help with 60Hz and 90Hz nulls. This is based on room measurements and comparing with the REW room sim, which is pretty accurate in...
  2. Building a new enclosure for a peerless xls10 with matching passive radiator (400gm)

    DIY Subwoofers - General Discussion
    This is my first time posting, although I've been a long time reader of the forums. I am rebuilding this sub in a new enclosure, with a new amp, since I did such a cheapo job last time I built it. I had basically just thrown it in an old Velodyne enclosure that was made for an 8 inch sub with...
  3. DIY sub Eminence LAB12C or XLS10 / XXLS12

    DIY Subwoofers - General Discussion
    Hi all i need advice what to buy/build I can get those drivers ; - Eminence LAB12C http://www.eminence.com/pdf/LAB_12C.pdf http://www.parts-express.com/eminence-lab-12c-high-power-12-subwoofer-speaker-driver-4-ohm--290-668 - Peerless XLS 10 / P830452...
  4. Peerless XLS10 P830452 car build

    Mobile Audio
    Hi guys, long time lurker here. I fancy the above driver in a 1.0 cubic feet box in a honda accord. Is this feasible? I don't have access to winISD at the moment. I'd like to think I'd get better SQ at lower cost compared with a JL 12w3v3 recommended by my local car audio outfit. Grateful for...
  5. Peerless XLS10 project on the tightest of budgets

    DIY Subwoofers - General Discussion
    Hi all, After seeing the amazing builds on this site, I knew it was the forum to join for an aspiring DIYer like myself. Anyway, after poking around on the internet for literally days, trying to absorb all that is "speaker building", I feel mostly settled on this nice 10" sub design I found on...
  6. Peerless xls10 with PRs

    DIY Subwoofers - General Discussion
    New to these forums so a big Hi to all, I have 2 xls10 peerless drivers and also 2 xls10p and was wondering what you would think was the best way to utilise these, 1 box with all four units in or 2 boxes with 1 of each in, or lastly 1 box with 2 PRs and 1 xls10, I am pretty good at diy so the...
Top