advice on Baomain AWG 6 Ferrule

1 - 1 of 1 Posts

dreadknot

Registered

Joined Jun 9, 2017

59 Posts

Discussion Starter • #1 • 9 mo ago

can you fit some JSC Wire 4 AWG Red High Current wire in this Baomain AWG 6 Ferrule an will this insert in the binding posts on the crown xls 1502

https://www.amazon.com/gp/product/B01I7XB848/ref=ox_sc_act_title_1?smid=A3HMB6GLG0WJ17&psc=1

1 - 1 of 1 Posts

Recommended Reading

Help with diy crossover build

DIY Audio

im building a threeway crossover with 600watt input at 8ohms my design to be as followed ( woofer input a 4ohms ) ( mids input at 4ohms ) ( highs input at 8ohms ) my intended crossover at 750hz an 6690hz my driver selection is two B&C 10PLB76 10IN WOOFERS & TWO PRV Audio WG275Ph 1" Midrange...
- 4
- 654
- dreadknot · updated 10 d ago
HELP ? DVC ISOBARIK SUB WIRING

DIY Audio

DOES ANY KNOW HOW TO WIRE TWO 4 DVC SUBS IN A CLAMSHELL ISOBARIK CONFIG OUT OF PHASE ,IV GOT TWO DUEL 4OHM SUBS THAT IM PUTTING IN TO A PORTED CLAMSHELL ISOBARIK CONFIG , AN IM NOT SURE HOW TO WIRED IT A VISUAL DIAGRAM WOULD BE HELPFUL IF ANYONE HAS ONE ,JUST TO NOTE IM AIMING FOR A PARALLEL...
- 1
- 240
- dreadknot · updated 5 mo ago
? W-frame open baffel sub build (advice needed)

DIY Audio

to anyone who knows how far from the wall should a slot-loaded W-frame open baffel sub build be depicked in https://www.hifizine.com/2012/12/subwoofer-origami/ https://www.hifizine.com/files/2012/03/Slot-loaded-W-frame.png
- 0
- 369
- dreadknot · updated 5 mo ago
PL-28II MODDING ADVICE

DIY Audio

does anyone know if can i replace the tweeter in the BIC Acoustech PL-28II Center Speaker with a planar tweet an replace the crossover with the Eminence PXB2:1K6 to lower the crossover from 2000hz to 1600hz which id prefur , the original has become very harsh sounding now ,im not sure if its...
- 0
- 325
- dreadknot · updated 5 mo ago
Replacing Amp - Where In-Wall Volume Controls are NOT Wired to Speakers

DIY Audio

I am trying to replace a 20+ year old Bose amplifier but I noticed that the six in-wall volume controls are NOT in series with their associated speakers. The controllers are wired solely to the amplifier (to slots labelled "Room #X Volume Control"). I am hoping to avoid re-wiring, but I can't...
- 1
- 322
- F
  Flood013 · updated 6 mo ago