[ifeliciano]

Hello gents,

I have a Soundblaster Audigy 2 ZS. Setup the card as outlined in the PDF for RMAA. At first I had a few issues, but after
a few tweaks ended up with the graph below. Does it look okay ?

 

[robbo266317]

It looks fairly typical to me.

Did you try a scan with the loopback in place? You should get a flat line if all is OK.

 

[ifeliciano]

It looks fairly typical to me.

Did you try a scan with the loopback in place? You should get a flat line if all is OK.

No..I'll try that tomorrow. Thanks !!

 

[ifeliciano]

It looks fairly typical to me.

Did you try a scan with the loopback in place? You should get a flat line if all is OK.

Is this what you meant by scan? :

 

[robbo266317]

Looking good. :T

 

[jm77040]

Hello, I am new to REW
Can some one tell me what are those three lines in the graph means?
Thanks

 

[brucek]

Can some one tell me what are those three lines in the graph means?

Your best bet is to read and become familiar with the REW HELP files. It will answer all your questions.

brucek

 

[jm77040]

Thanks, Brucek, will check the REW help files.

jm77040