Home Theater Forum and Systems banner

1 - 2 of 2 Posts

·
Registered
Joined
·
46 Posts
Discussion Starter #1
just ordered the 976 4K HDR HDMI AV Processor and i am looking for best configuration for use

crossover,eq,subtrim,and etc


i have this amp an speaker setup to pair with

5x crown xli 800 for the centers ,fronts,front wides, sides, backs and 1x xls 1502 for the subs

speakers are as followed

centers are the BIC Acoustech PL-28II Center Speaker - Black

fronts are the BIC Amercia Acoustech Platinum Series PL-89 tower speaker

front wides are the BIC America Venturi DV84 2-Way Tower Speaker, Black elevated 1 foot up and 1 foot out on wooden platform

from the front

sides are the BIC America Venturi DV84 2-Way Tower Speaker, Black

backs are the are the BIC America Venturi DV64 2-Way Tower Speaker, Black

suds are two 15in audiopipes in custom boxs

theater area is a 15foot wide by 17foot long with a 9foot ceiling

my previous processor config was with an onkyo 717 without front wides but everything else

in this crossover config 70hz for fronts 60hz for the centers 50hz for sides an backs an 65hz with external crossover control

all the xli 800 amp gain knobs were set at 20%

an the sub amp gain knobs were set at 45%

i had replaced the sub amp from a xli 1500 at 35% gain that seemed loader at 45% gain with the xls 1502 for the crossover control the xls 1502 at 45% gain seems as loud as that other did at 35% but that just me i guess

so any thoughts or advice would be much needed

i will be using xlr cables only
 
1 - 2 of 2 Posts
Top