Home Theater Forum and Systems banner
1 - 3 of 3 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter · #1 ·
Is there a way to bypass all the filtering present in the Behringer whilst leaving to connected? I have purchased a new AVR and want to run Audyssey first before equalising with the BFD. It is just too much work disconnecting everything and then reconnecting again. Alternatively, how can I reset all the filters that are present in the BFD from previous equalisations?
 

·
Super Moderator
Joined
·
9,349 Posts

Alternatively, how can I reset all the filters that are present in the BFD from previous equalisations?
There is no "Reset" function. You either have to turn off each filter manually by changing its gain setting from (+) or (-) to zero, switch the filter from "PA" to "OF" (off), or re-adjust the filters to any new settings you might choose. Alternately, you could "abandon" one memory setting and enter new filters in a different one.

Or as brucek mentioned, you can bypass everything with the front panel button.

Regards,
Wayne

 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top