Home Theater Forum and Systems banner
1 - 5 of 5 Posts

·
Registered
Joined
·
346 Posts
Discussion Starter · #1 ·
Since the BDF has dual channels can you use both channels to calibrate each sub, or would it be better to calibrate both subs at the same time using a single channel? So use the left channel of the BFD and calibrate that sub, then use the right channel to calibrate the right sub, or use both channels at the same time to calibrate both subs together. I have 2 Sub outs on my receiver.
 

·
Elite Shackster , HTS Moderator Emeritus
Joined
·
2,216 Posts
There's a whole subforum here with downloads for REW. In there you'll see our "standard" ECM8000 mic. We did a lot of comparisons with different mics, and for sub work that one will suit you well.

As for preamp/soundcard calibrations, you need to do those as part of the REW setup. The instructions for those are in the help file.

Good luck.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top