[mrsollars]

I have a set of Klipsch Pro Media 2.1 's with the sub that comes with them. I also have an older 8'' AIWA htib sub that i don't use anymore. is there any way that i can use this setup to in order to operate both subs.

i'll try to attach some pictures of the back of the subs. one is rca and the other (klipsch) is some proprietary plug.

Thanks Matt

 

[mrsollars]

the other end goes comes directly out of the inside of one of the speakers (klipsh).
so in a sense, there is no ''other end''.....it's the speaker.

from the klipsch website.....the wire with the funky connection end comes directly out of the back of the speaker with the knobs on it....

edit...sorry, out of the speaker with the knobs, and into the ''preamp input'' on the back of the sub.

 

[mrsollars]

now i'm all for cracking these open and soldering. i had an internal connection on my klipsch sub go out.....prompting the purchase and use of a soldering iron. this got my thinking, i wonder if i could do some more rewiring, etc and use both subs. is there anything you can think of?!?! any other pictures i could take. inside of either sub, etc.

thanks wayne.

matt

 

[mrsollars]

i'm not sure if you can tell, but the far left 'red/pos' speaker clip broke off on the back of the klipsch. it was spring loaded, and kept the speaker wire connected to the sub. well, broken, that speaker is useless. i think i'll skip the dual sub route and just solder the speaker wire back to the inside of that clip.
thanks for the help wayne.

matt