Home Theater Forum and Systems banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3,069 Posts
Discussion Starter #1
Hi there,

Can someone advise me on what is the best way to cut out accurate holes for the FI Q18's. I can't find anything to do this. Tips and tricks would be appreciated please.

Any videos would be very helpful if possible.

cheers

Graham
 

·
Banned
Joined
·
22,577 Posts
Check out our recommended tools thread.

The best method I have found is using a router and a circle jig... it makes a perfect cut. Of course you can always use the jigsaw, but for me those are less accurate.

I have the Bosch router shown in that link... I remove the bottom plate, screw on the circle jig, mark my center on the board, drill a small hole for the jig pin, insert the pin at the appropriate measurement and route away.

Maybe someone will have some pics.
 
1 - 3 of 3 Posts
Top