Home Theater Forum and Systems banner
1 - 1 of 1 Posts

·
Registered
Joined
·
166 Posts
Discussion Starter · #1 · (Edited)
Hi. I am now getting ready to install my filters to the 1100P. I am a little confused as to what channel I am to install the filters on. Does it matter which channel they are installed on? I just noticed that I am coming out of my xeny502 on the L channel CD/Tape RCA outs but running to R channel of the AUX2 of my AVR...which channel should I select for the filter assignment?


EDIT: If my SW only plays between 30-100 hz. and I have my crossover for my mains set to 80hz, do I need any filters below 30hz or above 80hz. for my filter assig. to the 1100?


Regards,

Bob
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top