Home Theater Forum and Systems banner
1 - 8 of 8 Posts
G

·
Discussion Starter · #1 ·
I have a Behringer DSP1100 which I have set up manually for my IFB sub some years ago. Now I would like to try setting it up with REQW but only the DSP1124 is mentioned in the guide.

Does anyone know if REQW would work with the DSP1100 also?
 

·
Premium Member
Joined
·
51 Posts
I have a Behringer DSP1100 which I have set up manually for my IFB sub some years ago. Now I would like to try setting it up with REQW but only the DSP1124 is mentioned in the guide.

Does anyone know if REQW would work with the DSP1100 also?
I'm trying to establish bidirectional connection to a DSP1100P,

via the 'retrieve filter settings from equaliser' but it is greyed out...
?
REW5 Beta5
would be nice to be able to request/receive a dump ...
and work with the filters in realtime

TIA

Klaus
 

·
Premium Member
Joined
·
6,711 Posts
Behringer do not (to my knowledge) publish the format of the dump output leaving no way to determine the corresponding filter settings, hence the interface to the BFD is send only.
 

·
Premium Member
Joined
·
6,711 Posts
Sure, the dump format is the same for in/out, but there is no information on how to interpret the values that are embedded within that dump. It is just a list of numbers, hence there is no way to show or control the corresponding filter settings from REW.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top