Home Theater Forum and Systems banner
1 - 1 of 58 Posts

· Registered
343 Posts
Any chance you've considered Soundsplinter's RL-i 8" in dual 4 ohm config?
They could be wired for a total of 4 ohms load to the amplifier, and I'm thinking would make better use of the power available.

I haven't run the sims yet, and the driver Q shows to be quite low - sow it might not be the best for a ported box.
1 - 1 of 58 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.