Home Theater Forum and Systems banner
1 - 3 of 3 Posts

· Registered
Joined
·
7,514 Posts
Push the PEQ button
turned on channel ( have tried 1,2 ect and 19,20 ect)
Push FREQ button and adjust
Push GAIN button and adjust
Push BANDWIDTH button and adjust
Push PEQ button and run REW
Be sure all the filters in the channel are set to parametric.

Remove all the filters and then play a tone with REW's Signal Generator (i.e. 50Hz) and have the tone coming through your sub (low volume). Then play with a single filter at 50Hz on the FBQ while the tone is playing to see what happens......

brucek
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top