Home Theater Forum and Systems banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi!

Just got a new FBQ2496 from the store. Firmware 1.1.
FBQ2496: Enabled midi and channel 1. Run mode.
Connected as described i help menu REW 5.13.
REW: Preferences set correct on all tabs (I think).
UM-1G connected to usb and installed ok, set to Passthrough off and Advanced off. UM-1G is recognized by windows (old pc with Vista).
Measured and made some filters to test out.

I am not able to send filters to FBQ2496. When selecting send, REW just hangs forever and I have to kill it.
No led activity seen on FBQ2496. Strange. I don't get it.

Any tips out there? Help is much appreciated!

Thanks,
Tom
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Thanks!
The log file did not tell much, stopped suddenly, so therefore...
Tried to uninstall REW, found some rubbish (old) REW files (from beta version) when going through folders on disk, rebooted and installed fresh again.

Works like a charm now!! :D

Happy man!!:D
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top