Home Theater Forum and Systems banner
1 - 6 of 6 Posts

· Registered
133 Posts
Discussion Starter · #1 ·
I was given a 15" driver that had some very minor cone damage. A little glue and it works like new. The problem is, it doesn't have an enclosure. I would like to build a ported cab for the speaker but I know virtually nothing about this particular woofer. It seems to work pretty well down to about 25 Hz; I hooked it up to my amp/receiver and played some sine waves through it.

Since I don't have any equipment, how would I find the T/S parameters to build the properly tuned box? Can I simply build a tuned enclosure at a low frequency such as 20 Hz and expect the woofer to sound decent?

The driver came out of a JBL MS115 full-range cab.
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.