[gperkins_1973]

Hi there,

Is it ok to fit FI Q18's into 25mm mdf using 30 hex bolts and T nuts. I forgot to double up on my inner panels for them.

cheers

Graham

 

[gperkins_1973]

Mike,


Thanks for that. Getting a bit paranoid. I was just going to use screws but figured t nuts would be better. I read somewhere that you have to hammer in the tnuts. Can you just put the bolt in and screw in the nut until it is tight in the wood. The guy from FI over here in the UK suggested glueing in the T nuts because they can fall out.

cheers

Graham

 

[gperkins_1973]

Mike,

Thanks for your help mate. Nipping out today to get some bits. I will see if I can get some off cuts of ply.

cheers again.

Graham