I just re-read your post, I was thinking that because the subs amp was dead that the sub would receive a full range signal....I missed the sub output part from the Denon to the Yamaha...oops, I also noticed that the BA's plate had an input that bypassed the subs crossover....I see what your getting at, I'm just a bit slow! Thanks, I will give it a try.
If the driver is bad it wont hurt the receiver will it?
it would hurt the receiver only if its rated impedence is low. test it with a multimeter but its probably 8 ohm. Below 8 ohm would hurt the receiver probably, however its tough to say because the receiver is used to driving several 8 ohm loads.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Home Theater Forum and Systems
742.3K posts
170.9K members
Since 2006
A forum community dedicated to home theater owners and enthusiasts. Come join the discussion about home audio/video, home theaters, troubleshooting, projects, DIY’s, product reviews and more!