Help! Meeeeeee
Join the discussion
Recommended Reading
-
Help with diy crossover build
DIY Audioim building a threeway crossover with 600watt input at 8ohms my design to be as followed ( woofer input a 4ohms ) ( mids input at 4ohms ) ( highs input at 8ohms ) my intended crossover at 750hz an 6690hz my driver selection is two B&C 10PLB76 10IN WOOFERS & TWO PRV Audio WG275Ph 1" Midrange...- 4
- 653
-
dreadknot · updated
-
HELP ? DVC ISOBARIK SUB WIRING
DIY AudioDOES ANY KNOW HOW TO WIRE TWO 4 DVC SUBS IN A CLAMSHELL ISOBARIK CONFIG OUT OF PHASE ,IV GOT TWO DUEL 4OHM SUBS THAT IM PUTTING IN TO A PORTED CLAMSHELL ISOBARIK CONFIG , AN IM NOT SURE HOW TO WIRED IT A VISUAL DIAGRAM WOULD BE HELPFUL IF ANYONE HAS ONE ,JUST TO NOTE IM AIMING FOR A PARALLEL...- 1
- 240
-
dreadknot · updated
-
? W-frame open baffel sub build (advice needed)
DIY Audioto anyone who knows how far from the wall should a slot-loaded W-frame open baffel sub build be depicked in https://www.hifizine.com/2012/12/subwoofer-origami/ https://www.hifizine.com/files/2012/03/Slot-loaded-W-frame.png- 0
- 369
-
dreadknot · updated
-
PL-28II MODDING ADVICE
DIY Audiodoes anyone know if can i replace the tweeter in the BIC Acoustech PL-28II Center Speaker with a planar tweet an replace the crossover with the Eminence PXB2:1K6 to lower the crossover from 2000hz to 1600hz which id prefur , the original has become very harsh sounding now ,im not sure if its...- 0
- 325
-
dreadknot · updated
-
Replacing Amp - Where In-Wall Volume Controls are NOT Wired to Speakers
DIY AudioI am trying to replace a 20+ year old Bose amplifier but I noticed that the six in-wall volume controls are NOT in series with their associated speakers. The controllers are wired solely to the amplifier (to slots labelled "Room #X Volume Control"). I am hoping to avoid re-wiring, but I can't...- 1
- 322
Join now to ask and comment!