[Jason1976]

the board is around 188 dollars after you send in the old one for a core charge. I had the same issue with mine the lamp light would flash. then after so long the standby temp light would come on. if I looked at the back of my set I could see the lamp lighting up.

you may want to try the reflow person we found, but since the bolt didn't bring anything back to life it may not work. It cost 40 dollars. So far it's been 4 days since he has had his board back and no issues. but we wan't to wait a little longer to make sure.

ps. my tv had the same issues as yours and the reflow would of worked if i wouldnt of messed the board up myself. I wish I would of just sent it off to the reflow person, but i didnt find him until after the fact.

 

[Jason1976]

if i open up my door on the back my tv comes up and shows video but after so long it turns off. the lamp lights. it's very rare for one of these switches to brake unless you brake off the plastic lever the door presses against.

another thing that may make it turn on is unplug it for about a week and then try plugging it in. and another thing to try is as you are trying to power it up. unplug and plug it back in many times as the lamp light is flashing. you may hear it make the start up sound then it will come on. even with the fix on mine i had to unplug it and plug in it a few times to make it give the start up sound then after that the tv would work until it was unplugged again or if the power went out. then i would have to do it all over again.

 

[Jason1976]

check the part number on www.samsungparts.com also check the part number on the sticker on the metal case of the digital board. I beleave it's BP94-02084A. the part number you gave is theASSY PCB MISC-ANALOG. you want the ASSY PCB MISC-DIGITAL//CHECK MODEL CODE.

 

[Jason1976]

Price $238.00 (core value: $50) . maybe you put pressure on the wrong chip. make sure you did it to the dnie chip on the digitial board. if that works then the 40 dollar reflow should work.