Home Theater Forum and Systems banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have just installed a new digital board and my tv screen was inverted vertically. So I went into standby pressed the mute-1-8-2-power to do a v-flip. My tv immediately shut down and is now blinking the lamp and standby. It will not power up. Any ideas? Bad sub-detect board?
 

·
Registered
Joined
·
730 Posts
You may of received a bad digtal board. Try unplugging it and giving it a brake. Also make sure you have the back on the tv and the safty switch is closed. if its open it will turn the tv off.
 

·
Plain ole user
Joined
·
11,121 Posts
What does the manual say about that LED combination?
 
1 - 3 of 3 Posts
Top