[harmann]

Finally found a good spot for my sub! Quick question: should I set the AVR crossover to highest when measuring sub alone? That's what I did anyway.

Sub: Elemental Designs A2-250
Mains: Energy C-100 (55hz at -3db)

Here comes the graphs :R

Sub alone

2 mains alone

Sub + 2 mains, 80hz crossover, 0 phase, level matched

70-125hz looks quite ugly... Any suggestions? :scratch:

Thanks!

 

[Wayne A. Pflughaupt]

Set the crossover for the frequency you normally use. That in itself might make a difference in the 70-125 Hz range...

Regards,
Wayne