How to access service menus in Mitsubishi WD-62526

15139 Views 5 Replies 1 Participant Last post by lcaillo, Oct 23, 2008

Discussion Starter · Oct 23, 2008

Mornin'

Trying to troubleshoot a problem with my WD where the picture just seems very very 'dim', for lack of a better term, and i'm trying to see if there's anything in the service menu that could be keeping the picture from being fully functional.

I've found multiple codes around for Mitsu TVs, but none of the codes seem to work, furthermor, my remote doesn't seem to have a "menu" button anywhere, apart from TV Menu and Device Menu, neither of which work.

Is there something i'm doing wrong? I have the correct remote for this set, yet the service codes i found out on the web doesn't seem to do anything when entered. Is it something about needing to enter the service menu code RIGHT at power on? What am I missing here?

Thanks In Advance

Save

1 - 3 of 6 Posts

lcaillo

· #2 · Oct 23, 2008

MENU, 2,4,7,0 gets you into the option menu. Select initialize and press ENTER. This will set all consumer adjustables to OOB condition and refresh the EEPROM. If that does not help, try going to the service menu with MENU, 2,4,5,7 and restore the backup factory data. That will reset all service level data to OOB condition.

None of this will likely help, as the most likey problem is a bad lamp.

Save

lcaillo

· #4 · Oct 23, 2008

Some of them are labelled TV Menu or something of the sort IIRC.

Save

lcaillo

· #6 · Oct 23, 2008

Press 0 after you get into the service mode.

Save

1 - 3 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month