[Brad f]

Hi Everybody,

Hopefully this is the correct place for this new post as I am new to Home Theatre Shack. I could not find thread on DHC 9.9.
I just bought a new Panasonic projector and electric screen. I have mounted a flat screen tv behind the projector screen. My question is, with my DHC 9.9 processor is there a way to play BLU ray source to a specific monitor i.e projector screen or tv? In the daytime I would like to use my t.v and in the evening use the projector. Therefore, I would like to toggle between one and the other. Is there a way to toggle between monitor out and monitor sub out on DHC 9.9 easily? By the way , I am using HDMI cable for input and output.

Thanks for any input guys,

Brad

 

[Brad f]

Thanks for the reply The Integra Dhc processor has 2 monitor outs (1 labeled monitor out and the other labeled monitor sub ) for HDMI. I was hoping that I would not have to go into the setup menu to toggle to the other monitor output. Maybe I could program my Harmony remote to do this? I am sure there must be a better way to use the same source but change the video display.

 

[Brad f]

Thanks for the link Marshall, I just ordered one. I spoke with Integra and they said you have to go into the setup menu to change display. I really wish they had of put a single command on the remote for the toggling between ( monitor out and monitor sub )displays easily.

 

[Brad f]

Hi Marshall, no luck with splitter just fuzzy screen? It sounded to easy

 

[Brad f]

It is inconsistent, the Integra receiver does not seem to see a input. I have sound but no picture.
Sometimes if I leave it on for a while it will eventually appear. Then I can turn on my projector and TV
they seem to work fine. If I shut off the system and turn it back on it won't work again?
Something I am noticing with the Integra DHC 9.9 is that the onscreen does not always working. I spoke with Integra and they said that is normal? Now I am wondering if I should use component Cables rather than HDMI? They told me that component would always show the onscreen. My luck with this Processor
is diminishing. I am surprised that a processor like this with all the great reviews would not show the onscreen in hdmi monitor out. If I was to use a component splitter would I loose the video quality? to my understanding hdmi is the only cable cable of passing 1080p for my Blu ray(is this True). Any input much appreciated.

 

[Brad f]

I tried the order, seemed to work a bit more consistent. Now I am finding that I must have both displays on at the same time for them to work? this is a bit of a problem as the tv is behind my drop down screen. Any thoughts?

 

[Brad f]

Finally some luck, I was able to get the Hex codes for my DHC 9.9. This allows me to switch outputs with one command , rather than going into the setup menu. I have no need for the HDMI splitter anymore. Huge help! I am still experiencing the OSD intermittent problem. Maybe if I confirm all equipment is turning on in certain sequence I may be able to resolve this? It would sure be nice to always have the onscreen volume as my equipment is hidden.