Home Theater Forum and Systems banner

1 - 3 of 3 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter #1
How do we set the initial recommended 75dB level of the AVR when using the REW?I understand that we should have the SPL meter RS or CM-140 to measure the 75dB but is this on a certain frequency initially say at 4khz just like the Rives Audio manual test CD recommended?or the REW gives a initial sweep of the frequency band selected and adjust the AVR volume to get the 75dB level?Using the sweep signal will not give a steady dB output level and the SPL will read varying signal level right?or is it using the pink noise to set the 75dB level?
 

·
Premium Member
Joined
·
15,054 Posts
75db is achieved by sending pink noise to each channel one at a time using an SPL meter at the listening position.
 
1 - 3 of 3 Posts
Top