Home Theater Forum and Systems banner
1 - 1 of 1 Posts

· Registered
33 Posts
Discussion Starter · #1 ·
How do we set the initial recommended 75dB level of the AVR when using the REW?I understand that we should have the SPL meter RS or CM-140 to measure the 75dB but is this on a certain frequency initially say at 4khz just like the Rives Audio manual test CD recommended?or the REW gives a initial sweep of the frequency band selected and adjust the AVR volume to get the 75dB level?Using the sweep signal will not give a steady dB output level and the SPL will read varying signal level right?or is it using the pink noise to set the 75dB level?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.