Home Theater Forum and Systems banner

1 - 11 of 11 Posts

·
Registered
Joined
·
44 Posts
Discussion Starter #1
Hello, new member here. To be honest, I joined to gain access to REW, but can see this is the right place to get the information I'll need to achieve the quality I am looking for.

I have a modest setup of:
  • Emotiva UMC-200 processor
  • JBL AVA-7 main amp
  • Adcom GFA-545 amp for front heights
  • Carver a-400x for my DIY Sonotube Shiva sub
  • NHT speakers (VT-1.2a mains, VS-1.2a center, and NHT SuperOnes for rears and front heights)
I've used the EMO-Q auto setup feature of the UMC-200, but I've never been completely satisfied with the EQ curves applied to the speakers. Then I read about REW, and knew this would enable me to get the best sound using the PEQ's in the UMC-200.

I am a musician, and have a PreSonus calibration mic I use to calibrate large room venues; So I decided to connect it through a Tascam US-122 box to my laptop and get REW up and running. I'm just now getting it installed and configured, and am sure I'll have questions along the way, and this looks like the right place to be!

Thanks,
Thomas.
 

·
Premium Member
Joined
·
15,054 Posts
Welcome aboard the HTS Thomas :wave:

Enjoy your stay with us.
 

·
Premium Member
Joined
·
5,802 Posts
Welcome to the SHACK, Thomas... Glad you joined. :T
 

·
Premium Member
Joined
·
3,374 Posts
Welcome aboard Thomas, Glad you could join us.....:wave:
 

·
Super Moderator
Joined
·
5,869 Posts
Hello and welcome to the forum. :wave:
 

·
Registered
Joined
·
44 Posts
Discussion Starter #10
Thanks guys, I appreciate the warm welcome. In browsing the forums for the past few hours, I think I'm almost ready to begin taking measurements ;)
 
1 - 11 of 11 Posts
Top