[mgl_sh]

Hi there,

Is REW able to work with parametric EQs like DBX? Or REW can only work with the designated EQ models in the software?

MAX

 

[Wayne A. Pflughaupt]

There is a "generic" setting under the "Equaliser" tab for any EQ not listed. However, it may take a bit of "trial and error" (i.e., sweep, tweak filters, sweep, re-tweak filters, etc.) for other equalizers, because the way filters are "configured" (for lack of a better term) varies from one EQ to the next. The trial and error could be bypassed by using REW's RTA mode.

Regards,
Wayne

 

[mgl_sh]

Thanks Wayne.

I have another question. If using ECM8000 as the test mic, should I point the mic to each speaker during the test or pointing it to the ceiling?

MAX

 

[brucek]

Point the ECM8000 at the ceiling when used at the listening position.......

brucek

 

[Wayne A. Pflughaupt]

Thanks Wayne.

I have another question. If using ECM8000 as the test mic, should I point the mic to each speaker during the test or pointing it to the ceiling?

MAX

This was discussed at some length recently at this thread. The last post (#40) by Dr.Who was the most informative - and the most definitive, I might add.

Regards,
Wayne