Home Theater Forum and Systems banner

1 - 6 of 6 Posts

·
Registered
Joined
·
347 Posts
Discussion Starter #1

·
Registered
Joined
·
347 Posts
Discussion Starter #3
Just out of curiosity, have you tried resetting the amp to factory defaults to see if it is a setting that has been incorrectly adjusted?
I have not. But like I side when used this sine wave freq generator app from phone straight to amp things seemed louder and more defined. When I introduced the AVR into the path things basically went lifeless. I cranked volume all the way and not hardly a change.
 

·
Registered
Joined
·
347 Posts
Discussion Starter #5
I did it both ways and then introduced the AVR. AVR is Onkyo 809. I had a sound issue right after warranty. It just quit. They fixed it. Apparently had too many instances of the same issue. Not sure if there is an unresolved issue as far as the preouts are concerned. I assume all 7.2 channels receive voltage from source. I dont have an amp for mains so I would not know.
 
1 - 6 of 6 Posts
Top