Jbl mpc 200

6390 Views 18 Replies 4 Participants Last post by salvasol, Sep 24, 2008

tcarcio

Discussion Starter · Aug 25, 2008

I was wondering if someone here can give me some, or some more, advice as to this amp. I know JBL makes some good stuff but I can get this amp for $150.00 and I was thinking of useing it for a subwoofer amp. I found out that it is high passed at 50hz and was wondering if it would be able to be adjusted down to 20hz. I do need a center channel amp so it might just be used for that but if it can be moded for a lower frequency easy enough I would use it for the sub. Also if any one has opinions about JBL amps in general I would love to hear them....Thanks....:scratchhead: Amp info..
http://www.allegrosound.com/JBL_MPC-600.pdf

Save

1 - 2 of 19 Posts

Mike P.

· #7 · Aug 27, 2008

I found out that it is high passed at 50hz and was wondering if it would be able to be adjusted down to 20hz

The MPC 200T amp is high passed at 50hz. The MPC 200 goes down to 20 hz. Which model did you get?

Save

Mike P.

· #9 · Aug 27, 2008

I got the info from the manual on the JBL site.

http://www.jblpro.com/pub/electronics/mpc_man.pdf

The amp does 225 W × 2 into 4 ohms from 20 Hz - 20 kHz, 0.1% THD. It also says 700 W into 4 ohms bridged at 1 kHz, 1% THD, so I'll guess 500 watts from 20 Hz - 20 kHz. For $150.00 you did good.

Save

1 - 2 of 19 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month