Home Theater Forum and Systems banner
1 - 1 of 8 Posts

· Registered
1,060 Posts
Re: looking for a simple answer... reciever to EP2500

The simple answer is for the EP2500, Behringer recommends running an unbalanced signal through the 1/4" TRS inputs with an unbalanced 1/4" TS plug or through the XLR inputs with the 1 and 3 pins bridged on a XLR connector. The input impedence drops by half as a result and no ART Cleanbox is needed. With a short run (under 5 meters) an unbalanced connection should be acceptable.

So you will need either of one of these types of connectors:

RCA male to 1/4" TS male unbalanced

RCA male to XLR male unbalanced
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.