Home Theater Forum and Systems banner

1 - 8 of 8 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hello!
I am looking for some advice and guidance through the jungles of REW.
I have been bumping my head against a wall here and even reading for days seems to have not born any fruits.
Running WIndows 7 (64bit), M-Audio Fast track Pro and a EMC 8000.
Here is my loopback for the Fast Track Audio. As far as I can tell it is rolling off at the low end way to fast. Is this correct?
I have the loop from the front 1(XLR) to the back 1 RCA. Any suggestions for troubleshooting?
 

Attachments

·
Registered
Joined
·
4 Posts
Discussion Starter #4
Thanks for the swift replies.
I tried another cable and the measurements are much more like it should be.
Seems like it does not like the XLR - RCA cables.

The buttons and knobs are set as follows on the Fast Track
Square 1:

Gain : Fully anticlockwise.
Pad: depressed
Inst/Line: depressed

Square 2:

Stereo/ Mono: Depressed
Mix: Fully Clockwise
Output: Almost Fully Clockwise
A/B: Depressed.
Headpone: Centre

Back:
RCA connected to Output 1.
Phanthom Power off.
Are all my settings correct?
Can I now do start the next step?
 

Attachments

1 - 8 of 8 Posts
Top