Home Theater Forum and Systems banner
1 - 2 of 4 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
My 65907 was having a intermittent hourglass shape but would pop back to normal.One day I went to turn it on it just made a pop and would not power up.The green light would stay on for 2 seconds and blink off.Through much research I concluded that I needed to replace the convergence IC's and 2 pico fuses.
Now when I plug it in i get the initial flashes indicating the processor is fired up and when i check the self diagnostics it flashes 1-2 indicating normal but i get no picture,there is sound but no picture.

Please Help
Going Nuts

billmtnman
 

· Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
I did replace IC's and pico fuses however I did get very inexpensive IC's from ebay, I think they cost me $10 for two. The IC's stated they were Sanyo but reading another post stated that a four number part number was a knockoff.

Thank you very much for your help
Billmtnman
 
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top