Hello, all.
Well, I think I have REW figured out (so far) . . .again, at least I think. I have calibrated my soundcard and using a new RS digital SPL meter w/ the appropriate calibration file from here. I know the RS meter isn't accurate past 6KHz(?).
Anyways, here is my first measurement of my mains (monitors; both channels). I will post individual channels shortly.
I am PC audio based w/ USB connectivity. Is there a way to mute the left and right channel in REW? If not, only way I can think of making individual measurements is to disconnect each speaker. (Using a Peachtree Nova. . .integrated amp w/ a built in USB DAC).
I will be integrating a sub and putting up room treatments over the next few weeks. My room isn't ideal, for sure. 11.4' L x 12.1' W x 7.9' H
Any suggestions on where to start? I can do some PC side EQ (via iTunes to Virtual Audio Cable to VSTHost & VSTs to ASIO4ALL to USB out)
Here are the plots:
Response Curve (to 200Hz)
Response Curve (to 20 KHz)
Waterfall
Well, I think I have REW figured out (so far) . . .again, at least I think. I have calibrated my soundcard and using a new RS digital SPL meter w/ the appropriate calibration file from here. I know the RS meter isn't accurate past 6KHz(?).
Anyways, here is my first measurement of my mains (monitors; both channels). I will post individual channels shortly.
I am PC audio based w/ USB connectivity. Is there a way to mute the left and right channel in REW? If not, only way I can think of making individual measurements is to disconnect each speaker. (Using a Peachtree Nova. . .integrated amp w/ a built in USB DAC).
I will be integrating a sub and putting up room treatments over the next few weeks. My room isn't ideal, for sure. 11.4' L x 12.1' W x 7.9' H
Any suggestions on where to start? I can do some PC side EQ (via iTunes to Virtual Audio Cable to VSTHost & VSTs to ASIO4ALL to USB out)
Here are the plots:
Response Curve (to 200Hz)
Response Curve (to 20 KHz)
Waterfall
