Home Theater Forum and Systems banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
15,054 Posts
Hello and welcome to the Shack!
1) What is the proper way to connect the receiver on the back panel of my Samsung LCD TV? Right now I have it hooked up from "Monitor Out" on the receiver to HDMI 1 on the back of my TV with an HDMI cable.
Yes this is the correct way.

2) How can I get my TV channels to play on my surround sound speakers?

when I have the receiver turned on the built in speakers on the TV turn off but no sound plays from the speakers when I have the "Source" on the TV set to TV. If I change the "Source" on the TV remote to HDMI 1 which is where I have the receiver plugged in and press "TV" on the receiver control I will get a black screen with no auido. I tried to see if maybe I have the speakers connected wrong or something but the speakers sound fine when I have the receiver changed to HDCP which is where I have my PS3 connected with an HDMI cable.
your tv will have an optical out for audio that you can use just run that back into the receivers TV input. Keep the TV on the "TV" input.

4) How would I go about connecting my PC to my Denon 1910 if I have my PC hooked up to my TV with a DVI to HDMI cable that doesnt have audio? I have a couple of optical cables laying around and an optical port on my motherboard.
again select the DVI input on the TV and run an optical cable from the PC to the receiver into an input you want to use
Hopefully this helps.
 

·
Premium Member
Joined
·
15,054 Posts
If it works then your in the socket properly and it only goes in one way. There should be a small snap when it is in properly.
 
1 - 2 of 2 Posts
Top