Home Theater Forum and Systems banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 · (Edited)
Hi all,

Just a newbie here - so maybe I'm asking stupid things..

Read the FAQ page and user manuals of REW and tried to complete a measurement.

First of all, the equipment in use:
Acer laptop - HDMI output used, feeding into Yamaha RX-V477 5.1 receiver. STRAIGHT mode used.
Mic - using the own calibration mic of the receiver, Yamaha / no model defined. Placed on top of tripod, approx at listening level.
Completed the mic SPL calibration (78 dB) using iphone Decibel app - I know it's far from perfect :/

Please proceed to 2nd message for measurements with corrected mic sensitivity.

Any ideas are more than welcome.
Thanks
Cem
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #2 ·
OK, found my first answer.. mic sensitivity was set to too low. Corrected and remeasured. Please ignore the first message. Now sharing the revised graphs.
 

Attachments

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
Finally, do I get it right? The RT60 calculation mostly shows around 850ms. Is it somewhere acceptable or should I bring it down using acoustic panels etc? My main use is movies and some music - but want some quality sound setup.

Thanks
 

Attachments

1 - 3 of 3 Posts
Top