Home Theater Forum and Systems banner
1 - 2 of 2 Posts

·
Plain ole user
Joined
·
11,121 Posts
It is hard to say. Convergence problems are the most common cause of shutdown in many sets, but there are many other potential problems as well. Youi can remove the convergence ICs and verify resistors and fuses are ok then start the set up with the chips out of circuit to test. The set will run with no convergence correction. I will move this thread to the Panasonic forum.
 

·
Plain ole user
Joined
·
11,121 Posts
Many meters are not accurate in low ohms. Verify that there is power to the ICs. You may have a blown fuse or open supply resistor and that can keep the set in shutdown. Otherwise the set should run with the ICs removed, even if the resitors on the output amp are open.
 
1 - 2 of 2 Posts
Top