Home Theater Forum and Systems banner

1 - 2 of 2 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter #1
Hello,
I have 2 to 5.1 converting board it takes L-G-R input and gives 6 channel output (5+1) here my problem is the filter board (2 to 5.1 board) gives subwoofer output as sub and ground (i:e 2 terminals only) but my power amplifier board or a low pass filter board needs a 3 terminal input (like L-G-R) how can i solve this problem ?
Thank you for reading ..

Sent from my m2 using Tapatalk
 

·
Registered
Joined
·
12 Posts
Friendly advice from someone who was molded in the social networks such as forums ... Stick to clean threads - makes people keen to helping you out.

As far as this thread goes ... it is fairly unclear for me to even give you an advice, you need to elaborate using concrete and detailed information about your issue.
 
1 - 2 of 2 Posts
Top