Home Theater Forum and Systems banner
1 - 4 of 4 Posts

·
Plain ole user
Joined
·
11,121 Posts
You most likely missed a connection somewhere.
 

·
Plain ole user
Joined
·
11,121 Posts
Even experienced techs miss one every now and then.
 

·
Plain ole user
Joined
·
11,121 Posts
I am not sure that an open resistor would cause no video. IIRC it would usually cause shut down and would likely damage an IC. Something else must have changed. You can pull the ICs and the set should run fine with no convergence correction. You will have no convergence, but you should get an image.

Maybe you cracked a solder joint moving the boards around. Not an uncommon issue. Did you adjust anything?
 

·
Plain ole user
Joined
·
11,121 Posts
Do you have scanning? Did you adjust the screen controls? Some sets are touchy about those controls.
 
1 - 4 of 4 Posts
Top