Home Theater Forum and Systems banner

Questions about WS55511

1805 Views 3 Replies 2 Participants Last post by  lcaillo
I am in the process of replacing the convergence chip and noticed the chip is only secured to the heatsink by a clamp. Do you think it would be okay to drill two holes and screw the chip to the heatsink? I'm not sure the clamp puts enough pressure on the chip to give good heat transfer. I would also like to know what is the best way to clean the lamps? They have about five years of dust on them. Thanks for any help you can give.
1 - 2 of 4 Posts
A mild cleaning solution is fine. I use a mix of 1 oz kodak photo flo, 1 oz isopropanol, and a quart of pure water with old cotton diapers and microfiber cloths.

The heat sink clamp is fine. You can bend it to hold tighter when you reinstall the IC. These sets were relatively reliable with respect to IC failures, so I don't think heat is that big of a deal.
Thanks for your response. Should I also clean the mirror and the inside of the screen the same way?
Posted via Mobile Device
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.