1 - 6 of 6 Posts

#### MatrixDweller

·
##### Registered
Joined
·
969 Posts
Discussion Starter · ·
I just finished laying down some laminate floor. I purchased the best underlay I could find, which was the Quiet Walk brand. It consists of a thin recycled cotton fiber pad and a vapor barrier.

I have about 2/3 of a roll left. I was wondering if I could use this to build panel absorbers and how well they would work. I can peel the vapor barrier off fairly easily and would layer them to form 2" or 3" thick panels. If it does work well I can always buy more on sale at \$35/100 sqft regularly \$55/100 sqft.

#### MatrixDweller

·
##### Registered
Joined
·
969 Posts
Discussion Starter · ·
It says 13.8lbs per 100sqft (or per roll not cubic feet). It seems to be about 1/8 of an inch. I'm not exactly sure how to do the lbs per cubic foot conversion.

I think that it is calculated as: 13.8 / 100 x 8 x 12 = ~13.2 lbs/cuft
(this would be like sandwiching 96 1ftx1ftx1/8" layers together)

#### MatrixDweller

·
##### Registered
Joined
·
969 Posts
Discussion Starter · ·
I think I have it calculated correctly in my post above as 13.2lbs/cuft. That doesn't take into acount small voids in the sandwich. It seems pretty dense to me. Maybe my calculation is off. A roll is 100 sqft by 1/8" thick and weights 13.8 lbs. It would take almost a whole roll sandwiched together in 1 ft squares to make 2" thickness. It's probably not too cost effective but since I have some laying around it might do. If it is so dense then maybe a 1" panel would do the trick.

#### MatrixDweller

·
##### Registered
Joined
·
969 Posts
Discussion Starter · ·
I forgot to subtract the weight of the plastic vapor barrier. The cuft density is probably more likely between 7 and 8 lbs/cuft or so assuming the vapor barrier is around 1/3 of the total weight. It's not 6 mil poly, more like 4 mil.

#### MatrixDweller

·
##### Registered
Joined
·
969 Posts
Discussion Starter · ·
Now I'm confused. Would that be the density at 1/8 of an inch?

Maybe I can just use that stuff to line the front and back of a panel instead of using polyester blanket filler. Then again it might be too reflective.

1 - 6 of 6 Posts