Home Theater Forum and Systems banner

1 - 8 of 8 Posts

·
Registered
Joined
·
261 Posts
Discussion Starter #1
I was attempting to generate some band limited white noise today and noticed that it can only go down to 10Hz. Is it possible to extend this? 5Hz would do, 1Hz would be great though
 

·
REW Author
Joined
·
6,711 Posts
The White PN signal is flat down to the lowest frequency of the chosen FFT length, which is below 1 Hz for 64k FFT and above (for the shortest 8k FFT the limit is just over 5 Hz at 44.1k sampling).
 

·
Registered
Joined
·
261 Posts
Discussion Starter #6
The White PN signal is flat down to the lowest frequency of the chosen FFT length, which is below 1 Hz for 64k FFT and above (for the shortest 8k FFT the limit is just over 5 Hz at 44.1k sampling).
ah ok so unchecking the low cut box expands the lower limit as opposed to it being user selectable?
 

·
REW Author
Joined
·
6,711 Posts
It was changed for the full range noise. The low and high cut controls are shared between pink and white noise signals, the pink signals follow the pink profile to 9 Hz so allowing lower cut frequencies for them would be misleading. Is there a particular requirement for varying the low cut below 10 Hz for the WhitePN signal?
 

·
Registered
Joined
·
261 Posts
Discussion Starter #8
It was changed for the full range noise. The low and high cut controls are shared between pink and white noise signals, the pink signals follow the pink profile to 9 Hz so allowing lower cut frequencies for them would be misleading. Is there a particular requirement for varying the low cut below 10 Hz for the WhitePN signal?
it's predominantly a UI issue as it's not obvious that unchecking the box results in a full range signal, it would be nice to have the option though to limit it to a particular frequency though just to have that extra flexibility in what sort of signal one can create.
 
1 - 8 of 8 Posts
Top