Home Theater Forum and Systems banner

1 - 6 of 6 Posts

·
Registered
Joined
·
75 Posts
Discussion Starter · #1 ·
Hello. I bought an interface to allow me to hook up my computer to my TV but have an unexpected problem. I can not view the lower half of the REW screen (everything else views fine???) no matter what I try, which is where the settings are that I need to get started. Has anyone had a similar problem that can offer some advice or is there another way to set the device types?

Thanks! Greg
 

·
Premium Member
Joined
·
6,711 Posts
What screen resolution are you using? Need 1024x768 minimum, some TVs only handle VGA (640x480).
 

·
Registered
Joined
·
75 Posts
Discussion Starter · #4 ·

·
Registered
Joined
·
75 Posts
Discussion Starter · #5 ·
That worked, but it's very hard to read. Thanks!
 

·
Registered
Joined
·
1,018 Posts
If you are running XP you can go into Control Panel>Display>Settings>Advanced>DPI settings and adjust the size of everything on the screen that way. (May mean a restart)

When I first obtained my LCD screen everything was sharp but just too small to read.

This tip from another forum member worked nicely. :T
 
1 - 6 of 6 Posts
Top