Home Theater Forum and Systems banner

1 - 2 of 2 Posts

·
Registered
Joined
·
98 Posts
Discussion Starter #1
So it's been a couple of years since I've played with REW and it's showing. New computer and I can't seem to get a good sound card calibration.

I have a simple stereo headphone to stereo headphone jack going from the line output to the line input on the computer.

Here is the soundcard calibration
https://drive.google.com/file/d/1P3PBv9uBhURciwLYDGkq-a9zl8khCQsb/view?usp=drivesdk

Here is the run sweep after the calibration
https://drive.google.com/file/d/1P4fH4dr0nZsKA8AT386o3WNHuhNIHZeZ/view?usp=drivesdk

No mic calibration turned on for either of these.

Help
Pete
 

·
REW Author
Joined
·
6,711 Posts
Glitches like that in the calibration result tend to be the result of dropouts in the audio data. You can't use a result like that to make a cal file, that just puts the same glitches on every measurement you make with that cal file. Try calibrating again, or doing a couple of runs to see if you get a clean response. Also try and ensure the computer isn't doing anything else at the time, like installing updates or anything that may place a heavy load on it. It may help to turn off WiFi or remove the network connection if it is wired.
 
1 - 2 of 2 Posts
Top