Home Theater Forum and Systems banner

1 - 6 of 6 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter #1
I would like to know how I should setup my speaker configuration in my Onkyo TX-NR515 7.1 AVR with my Klipsch RP-250 speakers
For example, should i put my front speakers on full band or 80hz


Sent from my iPhone using Tapatalk
 

·
Premium Member
Joined
·
15,054 Posts
Use 80hz, unless you have speakers that can truly handle below 20hz and your amp section can handle the extra load it's just not any real advantage.
 

·
Registered
Joined
·
21 Posts
Discussion Starter #3
Ok thanks, I just wrote 80hz as example but I can choose different kind of numbers, from 40-200hz


Sent from my iPhone using Tapatalk
 

·
Premium Member
Joined
·
5,794 Posts
Your speakers are rated down to +/- 3db to 35hz... Are you running a sub? If you are running a sub then I would crossover around 80HZ to make it easier on your amp.
 

·
Registered
Joined
·
21 Posts
Discussion Starter #5
Yes, I have the Klipsch sub R-110SW and also a Klipsch RP-250 centerspeaker, for the rears I use Q-acoustics 2010i


Sent from my iPhone using Tapatalk
 

·
Premium Member
Joined
·
15,054 Posts
80Hz is the THX recommended setting no matter what speakers you have.
 
1 - 6 of 6 Posts
Top