Sub pre-outs

1169 Views 2 Replies 2 Participants Last post by needspeed52, Dec 11, 2012

needspeed52

Discussion Starter · Dec 11, 2012

Hey guys,
My receiver has dual sub pre-outs but the same (identical) signal is output from both, should I use them both to my dual subs or just use one with a Y splitter to the subs, which do you reco, or does it not matter either way, I just thought I would ask if one method is preferred over the other. Thanks. :huh:
Jeff

Save

1 - 3 of 3 Posts

ALMFamily

· #2 · Dec 11, 2012

I do not think it matters Jeff. If I understand correctly, basically the unit has a splitter built inside. You are in essence doing the same thing the manufacturer has done in the build.

Save

needspeed52

Discussion Starter · #3 · Dec 11, 2012

ALMFamily said:
I do not think it matters Jeff. If I understand correctly, basically the unit has a splitter built inside. You are in essence doing the same thing the manufacturer has done in the build.

Thanks Joe, that's what I thought, just needed some verification from the audio Gurus here.:T
Cheers Jeff

Save

1 - 3 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month