Home Theater Forum and Systems banner
1 - 2 of 2 Posts

·
Registered
Joined
·
93 Posts
Discussion Starter · #1 ·
i am replacing a bad 10in driver in my celestion a6s. i am trying to determine which wire is + and -. the old driver does not have any marking on it's surface plate. the two wires that i removed are different colors.one is blue,the other is orange. the female connectors on these two wires are different sizes..
please advise..thank you..
 

·
Registered
Joined
·
93 Posts
Discussion Starter · #3 ·
hey dennis thanks for the response. i tried your suggestion and it worked. turns out that celestion had a red dot on the positive connector side. the battery test confirmed this. my new drivers should be here today on the fedex.:bigsmile::bigsmile: i am hoping this will be my first learning step toward a diy sub.
i'll post my repair result. thanks so much.
 
1 - 2 of 2 Posts
Top