Home Theater Forum and Systems banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
15,054 Posts
I think the only way that this will work is if you use a speaker selector switch hooked up backwards. If you run both receivers to the speaker you risk damaging the other receiver even if it is off.
 

·
Premium Member
Joined
·
15,054 Posts
Although I use two different sets of mains for my HT and TT systems, I use the same subs for both. Using the crossover in the sub amps for the TT system and switching it to LFE for the HT. I have never had any problem.
Yes, but you are only sending a line signal not a full amplified power feed from bolth receivers amp section as the OP wants to do.
 
1 - 2 of 2 Posts
Top