Home Theater Forum and Systems banner
1 - 2 of 2 Posts

·
Registered
Joined
·
168 Posts
Although I use two different sets of mains for my HT and TT systems, I use the same subs for both. Using the crossover in the sub amps for the TT system and switching it to LFE for the HT. I have never had any problem.
 

·
Registered
Joined
·
168 Posts
Yes, but you are only sending a line signal not a full amplified power feed from bolth receivers amp section as the OP wants to do.
Actually I'm sending a full range signal from the power amp of the TT system to both the L/R speakers and subs, using a pair of jumpers between the mains and subs, which is why I use the sub amp's XO to act as a low pass to the subs.
Its only on the HT side that I'm using a coax input to the subs.
And both are always connected to the subs, but like the op was asking, only one system is active at any given time.
 
1 - 2 of 2 Posts
Top